Inconsistent PLA Basic Jade White spools?

[Josh-3D]

I’ve seen a few people note this. So far it seems like it affects the black and white in the PLA basic line. @lildobber13 has a post up where this is discussed.

Tape at the end of spool

Small update regarding this, after Bambu asked for the SN’s, they refunded my purchase and allowed me to keep the filament. This would be the second bad batch they’d have me ship back. Once again, Bambu support was great and timely. I actually ran out of the new batch for a recent print and fortunately had one roll from my last purchase (the good batch purchased in April 2024). Since these rolls were the “same” PLA Basic Jade White, I wanted to see the difference in quality. As you can see in t…