Infill odity

[B1G-T0NE]

When my print requires an infill layer, the printer head returns to the back right corner of the bed first. Is this normal? if there is infill required high up in a model this takes quite a long time before it starts printing again

[PrinterMcgee]

Is the printer the A1?

A1 pause at the back corner?

My very first print with TPU and all the stringing, but that’s not what my question is about. Although if someone has some good A1 settings for cheap amazon tpu I would appreciate them. This pic provides an example of something I’ve been curious about since I got this printer. The the stringing to the back corner? This happens several times during each print, I’m rarely ever in the same building as the printer but I think it happens during every print, even when not using the AMS. The A1 w…

[B1G-T0NE]

Sorry I meant to put the details

My printer is the A1

[B1G-T0NE]

I have just found these lines in the gcode that send it to the back corner:

[PrinterMcgee]

Go in the settings and turn off “Nozzle Clump Detection”. That feature is only on the A1.

Nozzle Clumping Detection