Infill problem?

I have this problem in the marked area. The actual body that is being printed appears to stand out from the supporting structure. As a result, at some point he will bump into it and knock it over.
I suspect the infill is a matter of watch. Can this be?
I’ve now gone down to 5% inflation but as you can see in the picture it continues to warp.

Does anyone have any tips on how I can fix this?

Try Painted Supports for that area.

Thanks, that doesn’t solve the problem.

Of course I could set the distance between the supports to 0, but then the surface of the figure would be bad.
The structure is where it is needed, but there is too much tension on the part and this causes it to lift.