I tried my 0.2mm nozzle for the first time. Because I had some very light and very dark filaments for the print, I set the flush to 800.
The flushing becomes a blob, especially for the white filament. The printer cleans the nozzle and the plastic goes through the chute, so there was no negative effect on the print.
I am just wondering if this is normal, or should I be changing something in my settings?
The black was Bambu PLA Basic, the yellow was Ender PLA, and the white and red were Flashforge PLA Pro. I did the Flow Dynamics and Flow rate calibrations on each filament using the 0.2 nozzle.