Is this under extrusion?

[Hippie13]

P1S and Orca Slicer

PolyLite ASA

Temp: 260c

Bed: Textured PEI at 100c

Flow Rate: 0.9405 (previous was 0.95)

Pressure Advance: 0.018 (previous was 0.02)

4 top layers, 0.2 nozzle, 10% gyroid

I’m trying to tune this filament because the default profile isn’t giving me a good top layer, it’s very rough. This is after tuning flow rate and PA. I’m wondering if I picked the wrong number on the flow rate or PA

[Ashley]

Is hard to see from the quality of the photo (forum compression), can you upload some closer photo’s and maybe slightly from an angle also.

Thanks

[Hippie13]

@Ashley These photos should hopefully be better