Issue with Re-Printing: Printer Stuck at Model Loading

I’m not entirely sure what’s happening here, but I’m posting to see if anyone else has encountered a similar issue.

I finished a print and used the printer’s menu to start a re-print. Everything seemed fine, so I stepped away. However, I later received a notification on my app that the print had failed and was aborted. When I checked the printer, it was stuck at loading the model.

I couldn’t start a new print until I rebooted the printer.

And yes, I did remove the old print and cleaned the build plate before attempting the re-print. :wink:

Has anyone else experienced this? Any tips?

You didn’t post what printer your using, but this sounds like an SD Card issue.

1 Like

Sorry, it’s a X1 Carbon.
Can’t be SD-card, brand new and only happens when I try to re-print from the finish menu. But today I can’t see the re-print anymore, I switched to Swedish and after that I can no longer choose re-print.