I can’t seem to tune in my BL PETG prints on my A1. The filament is brand new and has been dried for 6 hours at 60C.
I’ve been playing with the nozzle temperature and bed temperatures alongside the fan speeds and can’t seem to get a good print. I’ve even lowered the speeds down a bit. The stock Bambu setting gives me the worst prints for some reason.
Bed gets a nice clean with dawn soap after each print. Any help would be appreciated.
I’m printing bambu petg on bambu petg profile just fine, but for other brands I’m doing calibrations if needed.
So I would say get an Orca slicer and go through calibrations it offers. Takes some time though.
And slow down another bit. I can print fast with PLA, with PETG not so much.
I also had some problems with Bambu Lab PETG Basic. After slowing down quite a lot and using other spools of Bambu PETG it’s working fine for me. Will try to dry the first spool to see whether there’s a difference, but I assume the most important thing is slowing down.
