LCD Upgrade for P1S?

[JonRaymond]

Specifically only the X1E has an actively heated changer (limited to 60c). The X1C and the P1S do not but the bed can heat the chamber too +50 degrees which helps a lot when printing ABS and ASA.

@Milos

Btw, I did some more research on this, and it turns out that the X1C has a feature where you use the heated chamber of the printer itself to dry out the filament (when not printing ofc).

The P1S can do this as well.

Filament Drying Feature on P1S

You can still dry filament on the P1S, you just have to set it manually. If you do not have a X1 series printer but have a P1S printer that also has a closed chamber, you can also dry the filaments by setting the bed temperatures to be the same as a X1 series printer‘s, and the operation during the drying process is the same. [不同耗材烘干条件en]