Bambu Lab Community Forum

Ledge failure

Bambu Lab P1 Series Troubleshooting

mltriebe December 10, 2024, 12:22am 10

Support Filament --> PETG for PLA and PLA for PETG and more Bambu Filament and Accesories

Hello all, because the PLA Support Filament in the Bambu Store is almost always sold out there is also another possibility. You can also use PETG for PLA and just PLA for PETG. PETG and PLA are printed at similar temperatures, but they can’t combine and so they are very good as a release material. This wisdom is not from me, but from the Youtube channel of Manbo. In this video it is explained again and shown the settings that should be made. Here is shown “only” PETG as suppoort for PLA. The …

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled