Manual for unclogging the P1S

Is there a decription for unclogging the p1S?
I can only find video’s on the X1 like this one: https://www.youtube.com/watch?v=AFlOVfbktAM
But I want to know how to start and stop extrude on the P1S.

This happened to me recently on a P1S. The video is accurate. Heat it up and nudge it with the extruder. Doesn’t work then push filament by hand. Doesn’t work then pull the hot end, heat it up and really push it. Only thing he didn’t mention is how to use the needle supplied with the kit.
How to extrude? Just look that up in the wiki.

Thanks I found a manual unclog method that will work for the P1S too.