The size of the otherwise nicely printed objects (standard PLA) systematically differs significantly from the measures shown in the slicer. The sample on the picture is smaller by more than 4% (>2mm of 50mm). I would say that there is an incorrect setting somewhere but I don’t see anything that might be wrong. Moreover, I have not messed with the advanced settings. Would appreciate any hints.
Uhm… It’s not 2mm smaller - read the measurement at the 0.
2 Likes
i hope this can help you :
Oops. Haven’t felt so stupid in a long time 
1 Like
No worries. Hope you feel better about the accuracy now. 
2 Likes
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.