Minor issue with PETG

[MZip]

@da-mkay - another user nailed down where he is seeing the break between PETG CF printing well and not so well. Good info in this. Might not be accurate for your PETG but it’s helping to get us numbers that are useful.

Problems with the new petg hf on A1

I would start with drying the filament again. Check that you have a hygrometer the can measure %RH well below 10%. I had a similar issue with “wet” filament. I bought some PETG-CF and dried it till the hygrometer showed 13%RH. The result looked terrible as you can see in the picture. [PXL_20240910_130141545] After drying it 6h longer the hygrometer showed only 7%RH and this was the printing result: [PXL_20240910_130158541] Between the two prints settings have not been changed. It is just t…