Modifiers are splitting object walls

[MalcTheOracle]

It was discussed in length here.

Modifiers just weaken the prints

I was attempting to strengthen a thin-walled model at a hinge joint, and the hinges all cracked along the modifier boundary line, making them far weaker than no modifier at all. You can see in the photo below how the edges don’t melt together as this boundary edge is clean with almost no scarring. Surely there’s some way to make the two outer walls along the boundary overlap enough to prevent this plane of weakness? [PXL_20241110_234030695~2]

There was no work around at the time.

You could turn this into a bug-report.