More Wall Loops only on one part of the Model

[IVZ]

Hello everyone, I would like to print the hole marked in green with 6 wall loops in the following part, while the remaining walls should only be 2 wall loops thick. How can I do that?

[highrise955]

Personally, I would create a cylinder modifier and position it in the hole and add the wall loops. However, more experienced people here might have a better way of doing it.

[dana.nelson]

@highrise955

Personally, I would create a cylinder modifier and position it in the hole and add the wall loops.

Yep, a cylinder modifier object is how I would do it too.

[IVZ]

Thank you so much, this saved me a lot of trial-and-error!