Hi all, is it ok to have multiple spools when drying ? I stacked 3 of them in there but not sure if the plate will move or any other reason not to do it? Try ing PETG for the first time and just found out I was supposed to dry first and was hoping to get them all out in one shot.
The plate must be removed to the very bottom. You can stack 2-3 bobbins on top of each other, but this drying will not be effective.
I use PETG every day and don’t dry anything. I print directly from the packaging. I had problems printing, I thought the PETG needed to be dried. But it was necessary to set the temperature to 255, at temperatures below I have defects. I was able to figure this out by printing the test parts from makerworld.
1 Like
Tell me something, perhaps I missed it… where on that wiki did it answer my question about stacking?
pretttttty much every single person on multiple forums said to dry it, and I did overnight which has notably made a difference on my calibration lines. I also did it with 3 in the chamber and seems to have been effective. I think you’re batting 1000 lol.