Hello,
I bought my X1C almost 2 years ago. What a printer ! But also, how disappointed I am with the quality of the updates to Bambulab studio or to the firmware. From my point of view, the printer operation has regressed since I bought it.
The problem for which I open this subject is that the printer used to stop and send alerts through the Android app in case AI detected a problem, such as first layer defect or spaghetti detection. But it no longer does it. It just sends a message, that of course I miss because I don’t have my nose permanently stuck to the app.
How can I have the same behavior as before : the printer stops and wait for an action from the operator in case AI detects a problem ?