Need Help identifying a plastic piece on a A1

Bambu Lab A1 Series General Discussions
1

IMG_20240802_172218
IMG_20240802_1722181920×3415 321 KB

Hello, this piece fell off while i was swapping out the anti-vibration pads i had installed under the printer, i have no idea where it’s from.

The support tickets are way to specific and are no help, so if anyone knows what this piece is or where i can find out where it is i would very much appreciate the help.

Thank you very much.

2

the A1 had a heatbed cable recall and your unit had the cable swapped at the factory, and Bambu added this piece on the back of the printer by the cable to prevent the cable from being smashed up against a wall. this part is not necessary, but you can glue it back on if you want.