[Bambu Error B] [Bambu Error A] I changed from a roll of ABS to PLA, but when I go to print I says I need to use ABS. I can’t print unless I choose ABS in the Prepare screen. How do I get past this?

That page just had a single roll of ABS shown and load/unload was grayed out. I went thru a few loads and unloads from the printer UI and finally a factory reset. It never asked what was on the spool post, but it did let me edit it from ABS to PLA. Printing now. Thanks for the help.

No print error

Bambu Lab P1 Series Troubleshooting

Voltage April 26, 2025, 7:18pm 4

I only own A-1’s and A-1 Mini’s and a X1C so maybe you could get some info from this link. Do you also have an AMS unit or not? I just looked in my slicer and you need to go to the DEVICE TAB and select the External Spool and change it there.