Normalize speed of non-model print procedures!

[Just_say_no_to_poop]

I noticed that the speed of the non-model printing procedures (nozzle cleaning, homing, changing filaments, etc) is directly impacted by the speed settings of the print.

For some prints where I need the model to print very slow (transparent petg), it adds many minutes to the beginning of the print because e v e r y t h i n g i s g o i n g s o s l o w . . . .

I can’t imagine this is intentional - I was wondering if this was on the radar as something to fix? These non-model procedures should happen at a standard speed regardless of the speed settings for the filament/model being printed.

[Olias]

I noticed this too. It is annoying to say the least but it’s unclear as to whether this is firmware or slicer related. My guess is that this is controlled by one of these two parameters although I haven’t tested this hypothesis.

Either way, it would be nice if there was a way to excluded startup movement speed from overall travel speed.