Nozzle crosses the wiper while cold after loading/unloading

Bambu Lab Software
,
1

Problem: Load Filament and Unload Filament option parks the nozzle to the left of the wiper. it cools down and crosses the wiper cold when doing anything after these actions, damaging the wiper.
Firmware Version: 01.03.00.00
Printer: Bambu Lab P1P
Steps to reproduce:

  1. Under the “Feeding” option on the printer, select load or unload.
  2. The printer loads or unloads the filament but leaves the nozzle to the left of the wiper.
  3. When you load filament after unloading or start a print after loading, the nozzle crosses the wiper cold.
  4. The wear on the wiper is increased.