Only two types of filament calibration in Bambu slicer for H2D?

Just flow and pressure advance. What about temperature tower? What about maximum flow rate?

There were many more in Orca slicer. Last time I checked (a while ago), it wasn’t clear if/when Orca slicer might come online for H2D, for… reasons.

Anyhow, for dialing in new filaments, what are we to do in the meantime between now and when either Bambu slicer offers it or Orca slicer has an H2D version? Are there equivalents for all of them in makerworld or elsewhere?

Well, perhaps answering my own question, I did find a temp tower on makerworld that alleges it works for H2D, so for now I guess the answer is we piecemeal this out rather than use calibration models built into the slicer for anything other than the two provided. That is, unless someone has anything more to add for an answer.

FWIW, I really do hope peace is made with Orca slicer and at some point there’s an H2D version of Orcaslicer. For anyone who has more than one brand of printer, it’s just very nice to have a consistent slicer interface for all of them, rather than each one adopt their own proprietary version with arbitrary differences to navigate.

3 Likes