Oops, something wrong

Other topics Share your setup
1

Okay, I printed this on another 3d printer, but it was something for my P1S, so…

I tried to make two holders for silicagel and it looked nice on the print. When I removed it from the plate though, the bottom came loose from the rest of it, and now it are just two open holders.

20231206_230321
20231206_2303211920×2560 168 KB

They look nice though.

2

After tight comes loose on which way ever :wink:

“Notch effect” bettwenn botom and walls, “Statics” in the objekt and “layer adhension” of the Matirial but if I start to talk about… so may better to wach on a few simple videos: