(P1P) Automatic AMS Refilling not showing in Bambu Studio

Bambu Lab Software
, ,
1

Hello!

Not sure if anyone else is experiencing this problem. But I am not able to check the box for the newly released AMS Refill feature for the P1P. When i click on the AMS options in Bambu Studio there are only the same three options that have always been there.

I updated Bambu Studio as well, and made sure that i was already on the most recent version of Bambu Handy. I could be wrong but support for this should have been in the most recent P1P Firmware update correct?

Appreciate any help, Thanks.

2

Do you have both cables plugged in to the hub and the ams. When I connected the ams I only used 1 cable and had the same problem. If you have everything connected correctly then on the printer go to the ams and make sure you set up the filaments there and then in Bambu Studio you need to click on the sink button to sink it to the ams.

3

Yes i do, have been using the AMS so that can only be the case. Not sure what the problem is still.