Like some others here I have been experiencing the P1P pausing for 3-4 seconds often during larger complex prints and even smaller prints less often.
This is causing artifacts on external surfaces and significantly increasing print times.
I have swapped out the included memory card with i high performance Sandisk SD card with slight improvement however it is still very much present.
This is either an overworked MCU or a bug in a feature which is causing comms issues as in other firmware/hardware combinations I’ve dealt with over the years it’s either comms bus filling up or high cpu causing these types of behaviour. This needs to be addressed as it is lowering the quality of prints significantly.
1 Like
Mine just started this 2 days ago. It is this way on a simple 4 wall round cap or a complex dragon. Changed SD cards, Formatted SD cards. Any Idea what was wrong?