'Preciate it! Could you maybe tell me what quality should I be aiming for with overhangs?
These are overhangs, printed all defaults for the “0.2mm Strength” system-preset process, printed with the same PLA and no Support W filament for support interfaces:
I only enabled supports. The middle is the cleanest but it was normal(auto), the left and right were both tree(auto). The farthest left is the cleanest tree print and it was all defaults for supports (the right was all defaults except 0.1mm Z distancing.
Are these overhangs the best I can get?
Edit: this is a photo of a test overhang print from earlier. The left print is a “tree supported, all the same PLA” print, and the right is a “normal support, PLA and Support W filaments” print
