I have had a bambu labs P1S for about a year now. Recently about 4-5 months ago at the time of this posting I have been having issues with my P1S. I have been having issues when I print anything that a 90°/right angle corner I get this rounded bulge on it. This only starts after the first few layer…

Please do a flow dynamics calibration on the filament and try again

Hello OE3D I did a dynamics flow and it did not correct the issue. Do you have any other suggestions that may assist?

Here is a little kicker to this situation. The purge tower is coming out amazing. Square edges. [17290465299952578916060547526316]

Some suggestions here on this post by @3dsurfr [image] Corners a bit rounded Bambu Lab X1 Series I did some tests on my own with a dovetail. I’m using Bambu PLA basic, 0.6 nozzle, “0.3mm standard” settings, standard Bambu filament profile. The result: [2023-08-09-17-24-…

What I haven’t seen mentioned in this thread is whether you’ve tried recalibrating the filament. It’s easy to assume the hardware needs maintenance, but more often than not, the filament is the simpler thing to adjust. Also, if you’re not experienced with hardware maintenance or lack the proper tool…

Thank you for this, I apologize for the delayed response I had something come up. I am currently doing this and trying to dial in my pressure advancing. I am doing test prints on that V style pattern and then on blocks to get an idea. I will report back when I have figured it out

P1S is printing round corners

Bambu Lab P Series Troubleshooting

Ukdavewood October 16, 2024, 8:42am 5

Some suggestions here on this post by @3dsurfr