P2S and PETG-HF works great!

[cpsadowski]

What brand of filaments? I’d suggest new users stick to Bambu filaments for the first 100 hours of printing

[user_254122797]

I found the forum that address the issues, Thanks

New P2S, constant first layer issues & print failures with PETG

Back with an update, after waiting a few days for the environment to warm up, and the humidity down to 9%, filament hopefully dried, a freshly cleaned plate and everything on default for PETG. Chamber temp was around 30º (Celsius) And this is what I’m greeted with., A failed calibration test. [IMG_3589] [IMG_3587] [IMG_3588] [IMG_3586] Compared to what it was once printing, which I thought was fantastic. [IMG_3591] [IMG_3592] And Support, on my support ticket is completely missing i…

[cpsadowski]

Did you resolve this? Curious to understand if the issue was filament or heat bed temps, or both. Thanks

[user_254122797]

I bought filament from HZST3D off Amazon and haven’t had any problems printing.

[user_1382660953]

I started having problems with PETG-HF last night. Bambu PETG-HF, .4 HF nozzle, stock settings.

I did a fairly large print with no issues. Started another print right after that and get nothing but clumps. Cleaned my plates. I have both the standard plate and the CoolPlate SuperTack. Tried with and without glue. Also tried two different PETG-HF rolls. Ran calibration and still clumps. Ran same print thru PLA and no issues. What could have happened between the successful print and the clumping? I made no changes.