It’s on “Traditional” since the beginning and always off when I launch a print.
But you might be onto something since the photo showed on the wiki page bare ressemblance with my printed result ( Timelapse Functionality Introduction | Bambu Lab Wiki )
I also learned that there was a faulty Timelapse GCode on the printer settings which may caused a similar problem (see Bypassing the Forced 3rd Layer Clump Detection - #3 by JsLS ) but I think it’s not my case.
You can see the travel here on one of my “faulty” print and it doesn’t show any of the “recalibrating pause” I experience :
