PA6-GF impossible to print

[ChaseH_3613312]

I made two changes to the default Bambu PA6-GF profile

Bed temp and chamber temp both at 50c

I used the standard texture plate with PA glue

This combo has worked for me every time.

See my post

PA6-GF Default Profile Too Hot - Works Great After Lowering Temps

I wanted to share my experience with Bambu’s PA6-GF filament. The default profile (100 °C bed, 65 °C chamber) runs too hot in my testing. Prints barely held on the smooth plate with glue and showed noticeable warping. On the textured plate, adhesion failed completely, even with glue. I opened a support case with Bambu before going down this path, but the response was that the material is simply prone to warping. Unfortunately, the possibility that the default temps might be the issue was ignore…