How do you print PAHT-CF ? Especially with models that size. As soon as I get over 2/3 area of the print bed I cannot avoid lifting. I had such a strong lift that because my adhesion is so good, it actually pulled the engineering plate off the magnet.
I read in the wiki that you need to use non linear, low % infill due to the tensile forces, but even at 5% gyroid I can’t get it to not lift / shrink … Like when I just add a primitive to the plate - 200x200x5 … default profile, 5% gyroid infill - I am unable to print that piece without seeing it lifting …
You can see here my post I made previously - it even pulled the writing off the engineering plate so any tips would be appreciated (although slighly OT for this thread)