Pair of tiny nuts in the bottom of my P1P?

These are just sitting at the bottom of my P1P, under the bed. Any idea where they might have come from?

1 Like

Don’t you just hate it when find tiny nuts under the bed? :yum: I always wondered whatever became of demasculated mice.

In truth, those category of nuts look like they may have come off either the power supply anchor or the control board. Have you tried placing the entire printer head’s down and looking at the underside of the printhead and control board? Not the PCB connected to the LCD but rather the control board accessible only if you remove the back plate.

Also, since this is a P1P, if I recall, there were nuts on the side of the frame albeit I covered mine up with an enclosure.

Most of the hardware on the P1P is black. I don’t see any exposed hardware that resembles anything close to those nuts on my P1P.

No nuts – only screws on the frame.

A neutered mouse? :rofl:
Sorry, couldn’t help myself