I was having adhesion problems with PLA on a textured plate. After washing the print plate, I raised the bed temp to 65 degrees. I also slowed down first layer print speed to 20 (from 50). On small parts, I use mouse ears (on auto). This has solved this problem for me.
Edit: I have been using a PEI textured plate. When I first started using it, everything stuck without any problems. Now prints fail. I used the method above to get prints to stick. I have found another solution on this forum. I can’t try it now, my printer is down. The described procedure strikes me as reasonable and logical. I will try it and let you know. See link below.
Good Luck