PLA Issues

I have two P1P printers. I’ve been printing in PETG exclusively for the past couple of weeks without issue.

Now that I’m trying to print PLA, I’ve got some problems. Printing the same model on my Ender 3 S1, the surface finish is shiny, but on the P1P its very matte. (identical material from same roll) Also the layers are not adhering to each other very well.

What settings should I be chasing down?

1 Like

slow down the speed. There are other posts about this subject and slowing down the speed will help.

Yup, this was the solution. I upped the temp to 245c, and dropped the Maximum Volumetric Speed to 7. It’s a lot slower but works better. Thanks!