Please add more settings to the Overhang Speed settings section

Bambu Lab Software Feature Requests
,
1

inside the speed tab, under overhang speed it would be aweseome if we could also have two checkboxes for

  • turn fans to 100% (or variable input) when doing overhangs
  • turn layer height to 0.08(or variable input) when doing overhangs

---------> this would allow us to archieve way better overhangs without manually changing somehitng in the gcode or a bunch of settings!

2

also a setting for turning the nozzle heat up maybe… i noticed 230 on pla give better results on overhangs than 220 when crazy print mode is used…

3

A hole 10.9mm diameter must be plugged at the top of the hole with a 30 degree over hang. Can the Bambu slicer generate lower layer heights at selected portion of a print? A variable layer would be the ultimate.

Tgoy99

lkraus 4