Possible Bug: Bed Crashing during print start

Bambu Lab Software Bambu Firmware
1

I wanted to report a possible bug

After the printer finishes a Large Print or a tall print. the bed will be all the way down. When I start a new print with bed leveling, the bed will go down slightly and i think it crashes into the bottom. There is a loud motor noise. It could be a normal sound, but not sure

1 Like
2

It is normal in that everyone’s printer does this. There are several ways Bambu could improve the firmware to prevent this from occurring.

3 Likes
3

Yep this is a know issue. You have to manually raise the bed say 10-20mm before starting another print to avoid this at the moment. Thats the only work around i know

2 Likes
4

Bumping thread/issue - please fix this @BambuLab

1 Like