Power System Plan: Models Come Alive! #4

I really wish MakerSupply parts considered the incompatible connections to power.

We have to use XH2.54, PH2.0, ZH1.5 & SH1.0 depending on which products are purchased.

Products like the rechargeable kit is the only one to use ZH1.5 connectors. It comes with either a 50 or 100mm cable, we do nit know which until it arrives (buzzard) and there are no ZH1.5 to ZH1.5 cables that can be purchased to guarantee a suitable length. There are no ZH1.5 connector adapter boards either.

The XH1.5 to SH1.0 cable is brand new. To make a longer cable, we need at least two ZH1.5 to SH1.0 cables and at least one SH1.0 to SH1.0 connector adapter boards. A lot of extras that take up space, make running cables in models difficult and needlessly increase the cost and risk of failure points.

The recently added XH2.54 to PH2.0 cable is a long overdue but welcome addition. However, the equivalent connector adapter boards have yet to materialise.

You only sell one separate li-ion battery. Three simple products come with different batteries with different connectors:

  • The rechargeable kit, with a different connector (the very unsupported ZH1.5).
  • The first water kit comes with a 3.7 volt li-ion using PH2.0 connector
  • The second water kit comes with a 7.4 volt li-ion kit using a PH2.0 connector.

Bigger kits like:

  • The vacuum kit comes with a bigger battery and yet another connector

That is five different li-ion batteries across five different sizes, four connectors and only one can be purchased individually.

The individually purchased one can’t connect to the rechargeable kit nor the power distribution board.

There are some ways to achieve some success by running cables together using a variety of adapters and cables that have different ends, but that just makes models and projects messy and unwieldy.

CyberBrick still lacks a USB rechargeable board option so the model (and remote controller) can be charged without having to disassemble the model. If the rechargeable power kit didn’t use the ZH1.5 connectors it could be used, but of course, no one thought any of this through.

Could we please have:

  • Cables to connect every combination of adapter you have used in the batteries or kits so we can connect them up together? In 100mm, 200mm and 300mm lengths at least
  • Connector adapter boards to connect every combination of adapter you have used in the batteries or kits so we can connect them up together? in 1 to 1, 1 to 2 and 1 to 4.
  • Multiple li-ion batteries sizes and voltages to achieve our aims efficiently and keeping in mind this article tells us to be aware of what and how we use things - so let us.
  • A USB rechargeable board for CyberBrick that can be embedded in a model. Ideally with a USB socket attached to the board by a cable and the same for the power switch and status LED. These would let designers locate the power switch, charge socket and status light unique to the models being designed rather than forcing the model to conform to the board?
  • A wiki guide to which batteries connect to with kits and vice versa. To be updated when new products launch.
  • A 3-pin version of this board SH1.0 to Dual SH1.0 Adapter