Hi.
On bambu Studio 1.7.7.89 (and orcaslicer 1.8 beta), I split the “CaliDragon” model with 2 different profiles P1P and X1C (I own an X1C) into standard 0.2 layers. I get a print time of 29m2s for P1P and 20m18s for X1C.
By printing the 2 “gcodes” on my X1C, I obtained a better finish with gcodes for P1P.
Also, what notable differences are there between the profiles, P1P and X1C ?
And how can you find the best compromise of the two to obtain a better finish with less time?
Complement: Depending on the 3D models of almost 10 hours, I have a usual gap of a few minutes but not 50%. And try the CaliDragon but the print quality is really better with the P1P profile! Could I have made a mistake in choosing my X1C 
Thanks in advance.
Astryan
