When asking for help, please provide as much information as possible about your inquiry.
This will help everyone to better understand your problem, and provide you with the best solution.
- Detailed description of the problem
- Printer model used
- Slicer settings used
- Type of filament used
- Photos that clearly show the problem
- .3mf file (if the file can be shared)
- Any potentially useful information that is related to the problem
Hello,
I have a bambu lab A1 for almost a year now.
Had some problems but great learning moments.
But recently i was printing a extra big print ( the Dutch Domtoren from Utrecht).
The base is almost a total build plate.
For the first 10/15cm it prints great but after then there are i think big later shifts end at constetly the same point the print makes a hard noise like its stuck and stopts go’s to the left and just starts printing like nothing is wrong.
I have a link to the videoclip when its happend.
What you see repeats.
I hope someone could help…
The picture you can see almost the Domtoren finished, only the biggest bottom print must be printed and thats saidly where the problems started.