Print Head Front Housing Holder

Other topics Share your prints
1

20230930_1609221
20230930_16092211920×2560 331 KB

I made this to hold up the Front Housing of the Print Head. Makes servicing the hot end much easier. I didn’t like stressing the wiring harness and connector by flipping it over the carbon rod as suggested by BL. Also, I avoid pulling connectors if at all possible. This tool avoids both and is easy to use and a quick print, so why not right?

Works for both the X1 and P1 printers. Here’s a link to it:

https://makerworld.com/en/u/1072890529

2 Likes
2

I’ve never had any issues just laying it over the top rod, but sure, why not? Looks like a good way to use up the last bit of PETG left on the spool :wink:

3

@Rom3oDelta7 :joy:, Haha, definitely a good way to use up the last bit of filament on a spool!