I know this isn’t helpful because there’s no solution on the thread below either, but it looks like other people were unsuccessful in stopping it also:
@acn I had this same issue about clumping detection. Simply pressing resume w/o doing anything else would complete the job without further issue. Thinking back to when it started happening, what I ended figure out was one of the “add ons” I printed was the culprit. I had printed out the hinged tool tray that sits on top of the flat surface above the display and screws into the z axis support. screwed on A1 Mini tool storage box with lid by Kri - MakerWorld . I think because it was so close to th…