Any chance Bambu Lab can share the profiles they used to print the items shown in the filament section of their online store? I have been printing using some of their filament and would really like to try using the slicer settings they have used to print the items they have posted to represent how their filament looks. I doubt it’s just the canned print profiles, but could be wrong. Specifically interested in the settings they use to slice the items shown for the PAHT-CF filament.
Pretty sure you could find them on MakerWorld
I thought the same but didn’t have any luck my initial attempt, albeit half hearted.
This…??
Was thinking more of the parts they display. Like the one’s below. I can find the part, where the makers listed have uploaded but I can’t find what slicer settings were use to print the part as displayed.
Google search the names under the models…
not google search makerworld search the @ names
Didn’t find 3DPrinterArt on MW when I searched, but Google found it.
It’s not hard to find the models, but the ones I looked at had profiles for PLA, not the PAHT-CF that @LuLu_Lab wants to use.
Which is why I rarely waste time using MW profiles. It’s quicker to work with the raw model and use my own settings rather than to hope that someone else, using different filament on a different printer, came up the magic numbers for my printer. Yeah, some of my prints fail, so I have to figure out why and try again. It’s called learning, so on the next model, I have the experience and knowledge to make better choices, and to use any filament I want.
1 Like