Printing at back of bed hit the poop shoot lever

Bambu Lab X1 Series Troubleshooting
1

I’m doing a massive print right now, going all the way to the edges of the plate. Whenever the printer head prints at the very edge of the back of the plate, it hits the lever from the poop shoot. It does it with every layer. Is this normal?

I’m wondering if it might be the cause of a couple of anomalies in some recent prints in the areas at the back of my prints.

2

I just noticed the same. Tried printing some big gridfinity boxes very close to the edge. The toolhead hit the poop chute lever which caused a layer shift and a failed print.

@TekNullOG Did you investigate this further?

3

I haven’t investigated further. Sorry.