Since updating the X1C firmware and Bambu Studio to their latest versions a week ago, I’ve noticed that at the end of a print, the X1C’s screen will frequently display “Printing Stopped”, rather than “Print Ended”. Bambu Handy notifies me on my phone that the print was successful and Bambu Studio shows no errors.
Why is the X1C displaying “Print Stopped” when the print was allowed to (and did) complete?
Same issue here. It did that to me today and I stared at the screen and the print for a good minute before deciding that it had indeed finished normally. Very confusing…
It did it at the end of 2 out of 3 prints today. Really weird! All prints were printed successfully and, like you, I waited before even opening the door!
Can confirm I also have experienced this since the update.
I experienced the same thing and I haven’t been able to figure out why.
Yep same here, thought it was something I was doing… very ood.
Hi folks, same annoying problem for me too with my X1C…
confirmed. I had the same error on 3 of 4 prints today.
All prints did complete normally, but the touchscreen reported print stopped instead of completed message.
Same confusion over here as well, been getting this message for past couple of days even though the print was successful. Since yesterday there was no such an error. Was very confused.