Printing suddenly stopped (Firmware 1.10)

Bambu Lab X1 Series Bambu Lab X1C
11

Still no answer from Bambu Support as to why my print suddenly failed without providing a reason.

This is what I tried -

  1. Roll back to 1.09.
  2. Reset defaults
  3. Offline upgrade to 1.10
  4. Reset defaults (stay offline only)
  5. Run full calibration
  6. Test print a tower with 1250 layers

So far so good. I have now started the print again I’ll update you all on (1) how the print went and (2) once I hear from Bambu Support on what specific issue stopped my print (they have the logs) and which version of the firmware will fix the “stopped without a reason” dialog.

Thanks!