Hello
I own X1C now for around a year.
Now I have a problem on most second Prints.
Firmware 1.7.2 and 1.7.3
First Print after Power on is allways fine.
When I start a new Job, sometimes the Printer cannot home Z axis, often or most Printer starts, heads up and on Homeing it becomes very loud.
Sounds a little bit like calibration, but it issn’t.
Any x/y move makes this sounds and haed moves slowly.
I had to stop and power off.
After power back anything works fine again.
Does anyone know this issue?
greetings
Ralf