I’m having underextrusion issues when printing color miniatures. This happens when there is a color change and a very small segment is printed, such as on the hands or face. There is also always an unevenness in the layers where the color is changed and I believe it is a related problem, but this al…

Try checking this support page Under extrusion | Bambu Lab Wiki

The problem it’s not the general sub extrusion, it’s just the color change, because when I print that same miniature in one color it only works correctly

What slicer did you use? Orca? Bambu?

I use Bambu, my settings are in 3mf archive

For such miniatures, I highly recommend switching to a 0,2mm nozzle. You will be amazed about the details. While this isn’t directly related to your problem, I wouldn’t be surprised if a smaller nozzle also improves things

[image] Alex_vG: For such miniatures, I highly recommend switching to a 0,2mm nozzle. You will be amazed about the details. Details on 0.2 are not exactly amazing, I presume you realise these figures are 25mm or so tall? When you take into account all the factors, it’s probably easier to jus…

[image] LordKitten: have a lot of problems with strings in miniatures even when using new filament. [Wet Filament] Filament Drying Recommendations | Bambu Lab Wiki [image] LordKitten: PLA, layer height 0.08mm, miniatures height is 5cm [image] Minimum Layer Height Li…

[quote=“Eponymous, post:7, topic:160232”] Details on 0.2 are not exactly amazing, I presume you realise these figures are 25mm or so tall? [/quote]. 50mm according to the OP. [image] Eponymous: Wargames groups, and almost certainly most events, generally won’t tolerate (as in, they will tell…

I didn’t find much in your profile that I would change. You have adjust a lot of settings, probably for a good reason. Some things, you might consider: You have disabled prime tower in favor of flush into infill. I think the nozzles don’t get properly primed because there is almost no infill in t…

I agree with @EnoTheThracian . You should worry about drying your filament before moving onto Z-hop and other extrusion issues. The fuzziness of the miniature shows that your filament has quite a lot of moisture.