X1C, Latest firmwares and software available is installed.
I have developed two problems that might be related?
Problem 1… The Purge Line skips on the first pass as if the head is too far back but on the second pass the other way is fine.
Problem 2… The printer will shift layers now after switching from one spool to the next from the AMS.
Outside of these two things, printing is fine. Only thing that I can think of that was done prior to this issue starting was a cleaning of the carbon fiber rods. I am reasonably sure I followed the directions correctly. I can’t figure out why these two things keep happening… I have rechecked the tensioning of the belts and ran the self-tests.
Any helpful advice would be greatly appreciated. Thank you!