Quality issue

Bambu Lab P1 Series Troubleshooting
1

Hello makers,

on a bambulab ps1 I have these imperfections … I have no idea what this is due to…

the printer has barely 20 hours of operation I use PLA-CF with steel nozzle and reinforced gear.
Overall, I’m very satisfied, but I think it can be fixed, don’t you?
thanks for your help!

printing in 0.12 / basic settings in Bambu studio

fig is 20 cm high / 9h30 printing time

IMG_7173
IMG_71731920×2560 298 KB

IMG_7172
IMG_71721920×2560 581 KB

IMG_7171
IMG_71711920×2560 562 KB

2

Maybe nozzle temperature is to low

1 Like
3

solution with manual calibration of flow rate and K factor.
Printouts are now perfect

4

Hold your eyes open: you get the same look in picture if the nozzle clogged or the extruder works not properly