Just replaced the tool head board and extruder after Bambu said that was my problem. I am sure I put everything back together. Well now the z axis goes up and I am having a hard time homing. This is what happens when it calibrate my A1. I’ve been looking on the forums and I found someone saying switch the eddy screws I’ve done that at least a dozen times. Nothing. Waiting to hear back from my help ticket. Anyone else have this issue?
Was told to unscrew the toolhead and push it down and screw it in again. I did that but the problem persisted. However i tilted the whole machine over and 3 eddy screws that I had job from replacing the toolhead board flew out. It must have been causing a short somewhere. Once the screws came out, printer had no problems calibrating and going home.
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.