Recurring "Paused" Error & Crashes on 16-Hour Print

Bambu Lab P1 Series Troubleshooting
1

lost power
lost power354×268 8.35 KB

Hey everyone, I’m really struggling with a 16-hour print. This is my third attempt, and each time I’m running into frustrating issues:

  • Attempt 1: Paused with an unspecified error. When I tried to resume, the print head crashed into the print and knocked off the cover.
  • Attempt 2: Lost power error, and I couldn’t resume the print.
  • Attempt 3: Paused twice with the same error as the first attempt.

I’ve already tried rebooting my printer and reformatting the SD card, but nothing has fixed it. Any ideas or suggestions would be greatly appreciated!

2

What do you mean by unspecified error?
Was there an error code like the one in the picture?
You can look the error code up in wiki.

If you entered the error number correctly in wiki search box, you can sometimes truncate the number to the first 8 - 10 digits and search wiki. I’ve done that and figured out the problem or got it down to a manageable number of hits to to where I could figure out the problem.